IPV4 100W Temperature Sensing Box Mod - by Pioneer4You

$44.95 $39.95
(You save $5.00)
Box shot of IPV4 by Pioneer4You

100W IPV 4 Box Mod from Pioneer4You

This is a mod by Pioneer4you called the IPV4. It has an output wattage capability of anything from 5 – 100 watts. There is a Yihi SX330 V3C chip installed as well as the temperature control feature. It is able to work with an atomizer that has really low resistance from 0.1 ohms which means that you can sub-ohm if you want to. The highest that it can cope with is 3.0ohms. The battery door has changed in this upgraded version. It is magnetic which makes it much easier to replace the two 18650 batteries when they have run out. It is easy to change the wattage using a plus or minus and the voltage will automatically be calculated based on the wattage that you choose. It is important that if you buy this you do have a good knowledge of the technologies in these sorts of devices so that you can set it up and use it safely. 

Package Contents:

  • iPV 4 Device
  • User manual
  • Gift Box
  • USB cable



  • Output Power: 5W - 100W
  • Output Voltage: 1.0V - 7.0V
  • Input Current: 1.3A - 40.0A
  • Efficiency 96%
  • Resistance: 0.1 - 3.0ohm (Non-Temp Sensing Mode)
  • Resistance (NI200): 0.05 - 0.1ohm
  • OLED Display
  • YIHI SX330 V4S Temperature Control Chip



  • Visual Operating System
  • Low Voltage Protection
  • Low Resistance Protection
  • High Input Voltage Warning
  • Short Circuite Protection
  • Reverse Battery Protection
  • Overheat Protection
  • Software Upgrade
  • Temperature Control (with NI200 coils): 200F - 580F